These T-Nuts are designed for the Ryobi BT3000 and BT3100 series Table saws, and work with the same function as T-Bolts, but without the fixed stud, allowing the user to attach any length stud or knob or bolt to it.

Available in 10-32 Thread. Black Oxide finished, 3/8" wide for the small fence and rail slots.

Use these T-Nuts with the available Threaded Studs to make your own T-Bolts in the lengths you need, when you need them, or use them with any of the appropriately sized and matching threaded Knobs or Adjustable Levers that are also available.

See the Specs page for where these are used and the dimensions available.
See the Notes page for information regarding the use of T-Nuts.

Commonly use to attach sacrificial fences and outfeed tables to the BT3K. This T-nut will also fit portions of the Jessem Router Fence.

Square: 3/8" Boss diameter: .25" 10-32 Used in: Rip Fence, Left Side Slot SMT Fence, Front Side Slot Rear Rail, Rear Slot

---

Choose your thread type before adding to Cart.

There may be times when a T-Nut is preferred over a T-Bolt, and vice-versa. A T-Bolt will not allow the threaded portion of the attachment to turn into the aluminum rail, as the T-Bolt is fixed at the T-Nut side, and any extra thread is taken up by the knob or attachment device outside of the rail.

A 5/16-18 T-Nut is a direct replacement for the stock Ryobi square T-Nut and will work in all areas except where the front and rear rails attach with the locking levers.

A T-Nut can remain inside the slot and will not protrude outside the edge of the rail, so jigs and fixtures can slide past or over them without the need to remove them.

T-Nuts and threaded studs in multiple lengths can be used to make T-Bolts as needed, with the custom length required for any given fixture.