Welcome to the Products Page

T-Nuts designed for the Ryobi BT3000 and BT3100 Table Saw and Woodworking System.

Custom turned from Alloy Steel and Black-Oxide coated for finish protection, these T-nuts are designed specifically for the Ryobi BT3000 and BT3100 Table Saw Woodworking System. There are 4 sizes available to fit all the slots on the Fences and Rails of the BT3K.

These may be purchased in any quantity of any size, and pricing discounts vary with the individual quantities.

Currently available threads are 5/16-18 (Ryobi style), 1/4-20 (common for some knobs), and 1/8" pilot-hole drilled for self drilling and tapping to custom threads (metric, etc). Small t-nuts are only available in 10-32 thread.

Large and Extra-Large pilot hole T-Nuts are only available with a silver zinc coating. The pictures shown here have not yet been updated. Except as noted, all T-Nuts will be black.

XLarge

Part #	Thread
XL5	5/16-18
XL4	1/4-20
XLPH	1/8" bore

Minor flats diameter: 1-1/8"
Boss diameter: <.80"

Rip Fence, Top Slot
SMT Fence, Top Slot
Rear Rail, Bottom Slot

Large

Part #	Thread
LG5	5/16-18
LG4	1/4-20
LGPH	1/8" bore

Minor flats diameter: 1"
Boss diameter: <.80"

Rip Fence, Right Side Slot
SMT Fence, Rear Side Slot
Front Rail, Inside Slot
Front Rail, Bottom Slot
Rear Rail, Inside Slot

Medium

Part #	Thread
MD5	5/16-18
MD4	1/4-20
MDPH	1/8" bore

Minor flats diameter: 7/8"
Boss diameter: <.530"

Front Rail, Top Slot
BT3000 and 3100

Small

Part #	Thread
SM10	10-32
SMPH	1/8" bore

Minor flats diameter: 3/8"
Boss diameter: .25"

Rip Fence, Left Side Slot

SMT Fence, Front Side Slot
Rear Rail, Rear Slot

		Pilot Hole
			Pilot Hole T-Nuts with 1/8" unthreaded bore. Medium T-Nuts are available only with a Black-Oxide finish. Large and Extra-Large are only available in a silver zinc coating. The picture does not yet show this. These T-Nuts can be drilled and tapped for inch or metric threads.

2004©